Secondary error code
Clicks: 152891
Author:
Error codes that can be fixed with this method: | ||
---|---|---|
Primary | Secondary Error code | |
![]() |
| |
![]() | ||
![]() | ||
![]() |
How to get the E-code
The E-code only shows up if you get 1 red light, otherwise there is no video output and you cant see it(for 2, 3 and 4 red lights)...(in rare cases it doesnt even show up if you get 1 red light, proceed with the secondary error code then)
An E-code consist out of 3 letters, it always starts with an E that is followed by two numbers, for example your error code would be E74 in the picture below!

How to get the Secondary error code
The specific type of hardware failure can be determined by a "hidden" error code
* Turn the xbox 360 on, and wait till the 3 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 3 red flashing lights.
You should be able to determine the difference between the 3 flashing lights and the error code lights by the rate in which they flash.
Here is how you interpret the LEDs to get the code number:
* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3
You will for example get an error code like 0102 if you get 4 lights after the first click, 1 after the second, 4 after the third and 2 after the fourth click of the eject button...
All credits for this go to Xbox-scene.com
Notice: The Tutorials have been done many times and were often successfull, however we cannot guarantee the success and so dont take any responsibility for any damages that might be caused by it, you do it on your own risk!!!